Sensorsoft ST6105J Uživatelský manuál stáhnout pdf (Strana 16)

Sensorsoft Remote Watchman Express/Client User Manual

Run Command Tab

Run command is useful if you require the ability to run an external software program, script or

batch file to take some corrective action or cause a physical change. Here are a few examples:

 Use the Windows Messenger Service to send a message to another computer

 Turn a relay (dry contact) ON or OFF

 Cause an emergency light to flash

 Unlock a doorway

 Turn on a backup air conditioner or heater

 Shutdown a computer

Many of the above examples will require additional software programs or hardware that you may

need to acquire. The User Executables folder in the software installation has a sr.exe program for

controlling the state of a Sensorsoft Relay (dry contact). The Sensorsoft Relay can be used to

control a variety of external equipment. Use the MS-DOS command lines shown below to turn

the relay ON or OFF:

C:\Progra~1\Sensor~1\Remote~1\Userex~1\sr ON com2

C:\Progra~1\Sensor~1\Remote~1\Userex~1\sr OFF com2

By default, the Run Command Tab is setup to use the Windows Messenger Service, (net.exe)

command to send messages to other computers. In order to make it work properly, you will need

to change ‘computer_name’ to a valid computer on your network.

Figure 5

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Žádné komentáře

Sensorsoft ST6105J Uživatelský manuál Strana 16